Refer to the
System Controller Instruction Manual for
basic operation of the system controller.
1.
Power
ON
and
screen
Turn ON the SCL power switch to display the
screen.
When the detectors and the
are properly connected,
is displayed at the right side of both
and
(when
two
detectors
are
connected).
Equipment connection for controlling the detectors by SCL is
defined on this screen. Highlighting the name of the unit defines
it
as being present and the system controller will perform a link check
upon power up. Unit definitions are displayed only once after the
initial installation. These definitions are stored in the SCL and are
required
only
once unless the system configuration is changed.
Module name
-
S Y S T E M
C O N F I G U R A T I O N
L
I N K E D
L I N K E D
L I N K E D
L
I N K E D
F R C
L I N K E D
L I N K E D
M E N U
P U M P .
L I N K E D
L O C A L
D E T .
B
L I N K E D
L O C A L
L I N K E D
L O C A L
,
Function line
Define
the
detector connection according to the following procedure
:
(1)
Display line a in the function line
as
in the following
figure. When b is displayed in the function line, press
once to change the display.
a
I
(2)
Select the detector connected to the function key and the
equipment name is highlighted on the screen.
Equipment of
display
does
not accept control by
even when its name is highlighted. Refer to section
5.5, Additional
Functions to change the local mode to the remote mode.
RID-1OA
Summary of Contents for RID-10A
