AR-M350 SIMULATIONS 10-53
<List of set values 1>
<List of display values 1>
<List of set values 2>
*
The selected tray is registered as an initial set value in the initial
screen.
At the above value + 10, the SPF enters the duplex mode (DD),
making duplex copies.
<List of set values 3>
(Adjustment procedure)
1) Select a paper feed tray to be used in the adjustment,
set the magnification ratio, and enter the adjustment item.
2) After entering the adjustment value, press START,
and printing is started.
3) Check the off-center (distance from the paper edge) of the copy.
Repeat procedure 2) until a satisfactory result is obtained.
50-12
Purpose
Adjustment
Function (Content)
Used to adjust the reading image center
position. (Adjusted for each document mode.)
Section
Image process (ICU)
Item
Picture quality
Operation/Procedure Perform the document print off-center
adjustment.
1) The current set value is highlighted on the
right of each item. In this screen, be sure to
select "1: COPY START." (Set value: 1)
2) Enter the correction value with 10 digit key
pad.
Press P to store the set value.
3) When the value of UNIT:0.1mm/STEP is
increased, the image is shifted toward the
front side.
4) Press START to start copying and store the
set value. (Display value: 1)
5) Select a paper feed tray. (Set value 2)
6) Set the scan magnification ratio. (Set value: 3)
SIMULATION 50-12
ORIGINAL OFF-CENTER ADJUSTMENT. SELECT 0-5, AND PRESS START.
0. TRAY SELECT
1. COPY START
2. MAGNIFICATION
3. PLATEN
4. SPF SIDE1
5. SPF SIDE2
2
SIMULATION 50-12
ORIGINAL OFF-CENTER ADJUSTMENT. INPUT VALUE 0-99, AND PRESS
START.
3. PLATEN
50
SIMULATION 50-12
ORIGINAL OFF-CENTER ADJUSTMENT. SELECT 1-15, AND PRESS START.
(FEED TRAY)
1. TRAY1 2. TRAY2 3. TRAY3 4. TRAY4
5. BPT
(ABOVE +10: DUPLEX MODE)
1
SIMULATION 50-12
ORIGINAL OFF-CENTER ADJUSTMENT. NOW COPYING.
SIMULATION 50-12
ORIGINAL OFF-CENTER ADJUSTMENT.
(MAGNIFICATION)
INPUT 25-400(%)
100
100
1
50
50
50
Press [CUSTOM SETTING] key.
Select other than 0 - 2,
and press [START] key.
Select 1, and
press [START] key.
Select 2, and
press [START] key.
Select 0, and
press [START] key.
Press [START] key.
Press [START] key or
press [CUSTOME SETTING] key.
Press [START] key or
press [CUSTOME SETTING] key.
Press [CUSTOM SETTING] key.
Or copying is terminated.
Default Set range
0 TRAY SELECT
Paper feed tray selection
-
1 ~ 5
1 COPY START
Copy start (Initial value)
-
2 MAGNIFICATION Print magnification ratio
setup (25 - 400%)
100
25 ~ 400
3 PLATEN
OC mode adjustment
50
0 ~ 99
4 SPF SIDE1 SPF
Front surface adjustment
50
0 ~ 99
5 SPF SIDE2 SPF
Back surface adjustment
50
0 ~ 99
Normal display
NOW COPYING
ERROR display
Door open
DOOR OPEN.
Jam
JAM
Paper empty
PAPER EMPTY.
1
TRAY1
2
TRAY2
3
TRAY3
4
TRAY4
5
Manual feed
Set range
25 - 400%
* !" #$%&'
