Sharp Actius PC-GP20, Operation Manual

Page: 84 / 114

6-5
6
Security Menu
Set Password defines the password (up to eight characters). See the next section
about the password setting.
If you lose your password, you will be unable to access the computer or
change the configuration. Make sure to select a password you will never
forget, or write it down and protect it in a secure place. Otherwise, you
will have to contact your dealer for assistance.
Hard Disk Virus Protect defines whether the boot sector of the hard disk is write-
protected. When formatting the hard disk or reinstalling software, set it to disabled.
Password
Setting a password will protect your computer against unauthorized access. When a
password is set, the system requires the password when entering the Setup Utility.
And if
Password On Boot is enabled, the system will require a password when the
computer is turned on. Refer to the next section.
If you enter a wrong password three times, the message “ The password is
incorrect. System will be shut down” appears. Press Enter to shut down
the computer, and after 10 seconds, press the power button to turn it on
again.
Setting the Password
1. In the Security menu of the Setup Utility, select Set Password and press Enter .
2. Type your password (up to eight characters), and press Enter .
3. Type the same password again, and press Enter .
4. If you want the password required when booting, confirm Password On Boot is
marked with .
5. Use Tab key to highlight OK and press Enter .
6. Select Exit menu and confirm Exit Saving Changes is highlighted; then press
Enter .
7. Confirm OK is highlighted and press Enter . The system restarts.