•
Any cart used to move the printer must have a surface able to support the full footprint of the printer.
•
Any cart used to move the hardware options must have a surface able to support the dimensions of the
options.
•
Keep the printer in an upright position.
•
Avoid severe jarring movements.
•
Make sure that your fingers are not under the printer when you set it down.
•
Make sure that there is adequate clearance around the printer.
Note:
Damage to the printer caused by improper moving is not covered by the printer warranty.
Shipping the printer
When shipping the printer, use the original packaging or contact the place where you purchased the printer.
Saving energy and paper
Configuring the power save mode settings
Sleep mode
1
From the control panel, navigate to:
Settings
>
Device
>
Power Management
>
Timeouts
>
Sleep Mode
For non-touch-screen printer models, press
to navigate through the settings.
2
Specify the amount of time that the printer stays idle before it enters Sleep Mode.
Hibernate mode
1
From the control panel, navigate to:
Settings
>
Device
>
Power Management
>
Timeouts
>
Hibernate Timeout
For non-touch-screen printer models, press
to navigate through the settings.
2
Select the amount of time that the printer stays idle before it enters Hibernate mode.
Notes:
•
For Hibernate Timeout to work, set Hibernate Timeout on Connection to Hibernate.
•
The Embedded Web Server is disabled when the printer is in Hibernate mode.
Adjusting the brightness of the printer display
1
From the home screen, touch
Settings
>
Device
>
Preferences
>
Screen Brightness
.
2
Adjust the setting.
Maintaining the printer
140
Summary of Contents for 679
