GB
SGM Technology for lighting
Palco Series
- 13 -
User’s Manual 1.03
I
NSTALLATION AND POSITIONING
Palco is an automated colour-changing fixture suitable for use in decorative/architectural and show
lighting. The type of installation can therefore be varied according to its use.
Palco can be permanently mounted, in the case of fixed installations, by means of the four holes on its
base, using the M6 screws as shown in the diagram. The distance between the holes is 180 mm on the
front and 204.5 mm on the side.
It’s also possible to fit a display safety cover to avoid any unauthorized use of the front control panel.
18
0.0
0
204
.50
The display cover is fitted as follows:
Loosen the hex screws fixing the horizontal positioning bracket using the 3 mm. key provided
Turn the bracket 45° to uncover the top fixing screws of the front panel
Remove the first two screws with a Phillips screwdriver (not supplied)
Turn the head’s horizontal positioning bracket –45° until the other two front panel screws can be seen
Remove the last two screws with a Phillips screwdriver (not supplied)
Now remove the front panel
Fit the protective cover to the display
Replace the front panel again, following the procedure described above
