GB
SGM Technology for lighting
Palco Series
- 37 -
User’s Manual 1.03
S
TEP
11
-
ENABLING
SCENES
Enabling a scene decides if the scene will be run or not when the program is run. The SCNRUN menu is
also useful when it is necessary to temporarily eliminate the playback of some scenes in a program
without cancelling them.
1.
Use the UP key to pass to the “SCNRUN=OFF” menu
2.
Press “Enter” and “SCNRUN=” will begin to flash
3.
Use the UP/DOWN keys to choose ON to enable the scene, or OFF if it
has not to be run.
4.
Press “Enter” to exit the SCNRN menu and confirm.
Repeat the above steps to program other scenes on the Palco.
Once programming is finished, keep “Enter” pressed down for approximately 6 sec. In order to exit the
PROGRAMMER menu.
S
TEP
12
-
PROGRAM
PLAYBACK
To start the playback of a program, access the PRGRUN menu
1.
Use the UP/DOWN keys to find the “PRGRUN” menu
2.
Press “Enter” and the displayed text will immediately begin to flash
3.
Use the UP/DOWN keys to choose the required programs from 1 to 5,
or OFF to stop the playback of the current program.
4.
Press “Enter” to exit the PRGRN menu and confirm.
5.2
The Event Scheduler
Scheduler is a Palco menu that allows to organize a series of 48 events over a period of a week and
which are repeated week after week. Each event can control the day and time of the start and finish of
one of the ten programs already prepared on board the Palco, in order to automate playback, without the
need for any external operators.
ATTENTION!
Before proceeding with the programming of the Scheduler, it’s important to set the
current date and time (See Chap. Menu - paragraph: Days of the week and time
S
TEP
1
-
CHOOSING
THE
EVENT
NUMBER
1.
Use the UP/DOWN keys to find the “SCHEDULER” menu
2.
Press “Enter” for a few seconds, until the following appears: “EVENT=1”
3.
If it is necessary to create a event other than number 1, press “Enter”
again and “EVENT=” will begin to flash
4.
Use the UP/DOWN keys to choose the required event, from 1 to 48,
then Press “Enter” to exit the EVENT menu and confirm..
S
TEP
2
-
CHOOSING
THE
PROGRAM
NUMBER
1.
Use the UP key to pass to the “PROGRAM=1” menu
2.
Press “Enter” and “PROGRAM=” will begin to flash
3.
Use the UP/DOWN keys to choose the required program number (from
1 to 5) to be controlled by Scheduler.
4.
Press “Enter” to exit the PROGRAM menu and confirm
PROGRAM=5
EVENT=1
SCHEDULER
PRGRUN=1
SCNRUN=ON
