GB
SGM Technology for lighting
Palco Series
- 39 -
User’s Manual 1.03
S
TEP
5
-
END
TIME
END TIME is used to configure: the hour, minutes and seconds in which an event containing a previously
prepared program will end.
1.
Use the UP key to pass to the “END_h=0” menu
2.
Press “Enter” and “END_h=” will begin to flash
3.
Use the UP/DOWN keys to choose the hour at which the program has to
end (from 0 to 23)
4.
Press “Enter” to exit the “END_h” menu and confirm.
1.
Use the UP key to pass to the “END_m=0” menu
2.
Press “Enter” and “END_m=” will begin to flash
3.
Use the UP/DOWN keys to choose the minutes at which the program
has to end (from 0 to 59)
4.
Press “Enter” to exit t.
1.
Use the UP key to pass to the “END_s=0” menu
2.
Press “Enter” and “END_s=” will begin to flash
3.
Use the UP/DOWN keys to choose the seconds at which the program
has to end (from 0 to 59)
4.
Press “Enter” to exit the “END_s” menu and confirm.
S
TEP
6
-
ENABLING
AN
EVENT
1.
Use the UP key to pass to the “ENABLE=OFF” menu
2.
Press “Enter” and “ENABLE=” will begin to flash
3.
Use the UP/DOWN keys to choose ON to enable the event, or OFF if it is
to be disabled.
4.
Press “Enter” to exit the “ENABLE” menu and confirm.
Repeat the above steps to program other events on the Palco.
Once programming is finished, keep “Enter” pressed down for approximately 6 sec. In order to exit the
SCHEDULER menu.
S
TEP
7
-
ENABLING
THE
SCHEDULER
To start the scheduler and all its “Actions”, it’s necessary to enter the SCHEDL=ON menu
1.
Use the UP/DOWN keys to find the “SCHEDL=ON” menu
2.
Press “Enter” and SCHEDL= will immediately begin to flash
3.
Use the UP/DOWN keys to choose ON or OFF, according to
requirements
4.
Press “Enter” to exit the SCHEDL=ON menu and confirm.
PRGRUN=1
ENABLE=ON
END_s=30
END_m=30
END_h=23
