SGM Technology for Lighting
GB
User’s Manual 1.03
- 28 -
Palco Series
D
ISPLAY BRIGHTNESS
Operators can select one of the brightnesses available for the Palco (standard or very low). This option
was included for theatre and television use, where excessive brightness can be disturbing. To adjust
display brightness, proceed as follows:
1.
Use the UP/DOWN keys to find the “Bright” menu
2.
Press “Enter” to confirm the choice. The text on the display will begin to
flash.
3.
Use the UP/DOWN keys to select the required option from those
available.
4.
Press “Enter” to confirm the changes.
I
NVERT DISPLAY
When the fixture is suspended “upside down” from a structure, the operator can turn the text on the
display through 180°, thus enabling the menus available to be easily read.
To change the reading angle, proceed as follows:
1.
Use the UP/DOWN keys to find the “Dspl Flip” menu
2.
Press “Enter” to confirm the choice. The text on the display will begin to
flash.
3.
Use the UP/DOWN keys to select the required option.
4.
Press “Enter” to confirm the changes.
DMX
DELAY
It’s possible to decide for how many seconds the fixture must hold the last operating status if there is no
DMX signal. “Delay” time can be set between 0 and 998 seconds. If set at UNL, the fixture will hold its
standby status for an unlimited time. This function is indispensable in the event of the DMX signal being
accidentally interrupted. To set the required time, proceed as follows:
1.
Use the UP/DOWN keys to find the “DMXDLY” menu
2.
Press “Enter” to confirm the choice. The text on the display will begin to
flash.
3.
Use the UP/DOWN keys to select the required length of time. If UNL
(unlimited) is set, the last valid operating status is held no matter for
how long the DMX signal is missing.
4.
Press “Enter” to confirm the changes.
D
AYS OF THE WEEK
It is of fundamental importance to set the day of the week on the Palco if it has to be used later in Stand-
alone mode.
1.
Use the UP/DOWN keys to find the “DAY” menu
2.
Press “Enter” to confirm the choice. The text on the display will begin to
flash.
3.
Use the UP/DOWN keys to select the current day of the week.
4.
Press “Enter” to confirm.
DAY=TUE
DMXDLY=20
DSPL FLIP
BRIGHT=40%
