SEW MOVITRAC LTE-B series, Operating Instructions Manual

Page: 8 / 80

8
Operating Instructions – MOVITRAC® LTE-B
2
Designated use
Safety Notes
Any electronic work may only be performed by adequately qualified electricians. Quali-
fied electricians in the context of this documentation are persons familiar with electrical
installation, startup, troubleshooting and servicing of the product who possess the
following qualifications:
• Training in electrical engineering, e.g. as an electrician or mechatronics technician
(final examinations must have been passed).
• They are familiar with this documentation.
In addition to that, they must be familiar with the relevant safety regulations and laws,
especially with the requirements of the performance levels according to
DIN EN ISO 13849-1 and all other standards, directives and laws specified in this
documentation. The above mentioned persons must have the authorization expressly
issued by the company to operate, program, configure, label and ground units, systems
and circuits in accordance with the standards of safety technology.
All work in further areas of transportation, storage, operation and waste disposal must
only be carried out by persons who are trained appropriately.
2.4 Designated use
Frequency inverters are components for controlling asynchronous AC motors. Fre-
quency inverters are intended for installation in electrical systems or machines. Never
connect capacitive loads. Operation with capacitive loads results in over voltages and
may destroy the unit.
The following standards apply, if the frequency inverters are marketed in the EU/EFTA:
• In case of installation in machines, startup of the drive inverters (meaning the start of
proper use) is prohibited until it is determined that the machine meets the require-
ments stipulated in Directive 2006/42/EC (machine directive); observe EN 60204.
• Startup (i.e. the start of designated use) is only permitted under observance of the
EMC (2004/108/EC) directive.
• The frequency inverters comply with the requirements of the Low Voltage Directive
2006/95/EC. The harmonized standards of the EN 61800-5-1/DIN VDE T105 series
in connection with EN 60439-1/VDE 0660 part 500 and EN 60146/VDE 0558 are ap-
plied to these frequency inverters.
Observe the technical data and the connection requirements specified on the nameplate
and the operating instructions.
2.5 Transport
Inspect the shipment for any damage that may have occurred in transit as soon as you
receive the delivery. Inform the shipping company immediately. You may need to pre-
clude startup.
Note the following points regarding transport:
• Before transportation, cover the connections with the supplied protection caps.
• Place the unit only on the cooling fins or on a side without connectors during trans-
portation.
• Ensure that the unit is not subject to mechanical impact during transportation.
If necessary, use suitable, sufficiently rated handling equipment. Prior to startup, re-
move the securing devices used for transportation.
Observe the notes on climatic conditions as stated in the “Technical Data” chapter.