SEW MOVITRAC LTE-B series, Operating Instructions Manual

Page: 32 / 80

32
Operating Instructions – MOVITRAC® LTE-B
5
User interface
Startup
5 Startup
5.1 User interface
5.1.1 Keypad
Each MOVITRAC
®
LTE-B has an integrated keypad as standard, allowing drive opera-
tion and setup without any additional equipment.
The keypad consists of 5 keys with the following functions:
The <start> / <stop> keys on the keypad are disabled when the parameters have their
factory default settings. To enable the operation of the <start> / <stop> keys on the
keypad, set
P-12 to 1 or 2 (see chapter "Standard parameters").
The Navigate key alone is used to gain access to the parameter edit menu. Pressing
and holding this key (> 1 sec) allows you to toggle between the parameter edit menu
and the real time display (where the drive operating status / running speed is displayed).
By pressing this key (< 1 sec), you can toggle between the operating speed and oper-
ating current during drive operation.
• INFORMATION
To reset to factory default settings, press the <up>, <down>, and <stop> keys
simultaneously for > 2 s. The display then shows "P-deF". Press the <stop> key to
acknowledge the change and to reset the drive.
5.1.2 Display
A standard 6-digit, 7-segment display is integrated into each drive to allow drive
operation to be monitored and parameters to be set.
Key Function
Start / Run • Enables running of motor
• Reverses direction of rotation if bi-directional keypad mode is enabled
Stop / Reset • Stops motor
• Resets a tripped drive
Navigate • Displays real time information
• Press and hold to enter / exit parameter mode
• Stores parameter changes
Up • Increases speed in real time mode
• Increases parameter values in parameter edit mode
Down • Decreases speed in real time mode
• Decreases parameter values in parameter edit mode
2933664395
[1] Display [4] Navigate
[2] Start [5] Up
[3] Stop / Reset [6] Down
MO
VITRA
C
®
LT
[4]
[5]
[6]
[1]
[2]
[3]
00
I