3-5
INSP
ADJ
E
POWER UNIT
6. Install:
●
Engine oil filler cap
7. Check:
●
Engine oil level
Refer to “Engine oil level”.
NOTE:
●
Run the engine for several minutes, turn it
off, and then check the engine oil level.
●
If the engine oil is still not at the proper
level, add or drain as needed.
Valve clearance adjustment
NOTE:
Valve clearance adjustment should be
made on a cold engine, at room tempera-
ture.
1. Measure:
●
Intake valve clearance
a
●
Exhaust valve clearance
b
Use feeler gauge.
Out of specification
→
Adjust.
Valve clearance:
Intake:
0.2
±
0.05 mm
(0.008
±
0.002 in)
Exhaust: 0.3
±
0.05 mm
(0.012
±
0.002 in)
Measurement steps:
●
Disconnect the fuel hoses
1
, ignition
coil leads and spark plug leads
2
.
●
Remove the cylinder head cover.
●
Turn the flywheel magneto and align
mark “
”
3
on the driven sprocket
with mark “
”
4
on the cylinder
block.
●
Measure the valve clearance using the
feeler gauge for cylinder #1.
●
Align mark “
●
”
5
on the driven
sprocket with mark “
”
4
on the cyl-
inder block and then measure the
valve clearance for cylinder #2.
Summary of Contents for Moray 25
Page 1: ...SERVICE MANUAL MANUEL D ENTRETIEN WARTUNGSANLEITUNG MANUAL DE SERVICIO E F D ES Moray 25...
Page 262: ...E BRKT SWIVEL BRACKET 7 17 EXPLODED DIAGRAM 7 17 REMOVAL AND INSTALLATION CHART 7 17...
Page 356: ...E TRBL ANLS CHAPTER 9 TROUBLE ANALYSIS TROUBLE ANALYSIS 9 1 TROUBLE ANALYSIS CHART 9 1...