3-26
4hours
:
Set “AUTO” parameter in “EDGE CUT TIME”
menu to 4 hours.
MANUAL :
Set “AUTO” parameter in “EDGE CUT TIME”
menu to the value set in “C_EDGE CUT TIME”
menu.
(13) Custom paper edge cut time (C_EDGE CUT TIME)
C_EDGE CUT TIME menu is displayed when MANUAL is se-
lected in C_EDGE CUT MODE.
Set a paper edge cut time for the custom paper selected.
<Parameter (Enter a value)>
Enter a three-digit decimal value in minutes.
(30 to 999 minutes)
(14) Custom paper cut sequence (C_CUT SEQUENCE) [Initial value: OFF]
Set a cut sequence for the custom paper selected.
<Parameter (Enter a choice)>
OFF
: Do not cut.
SEQUENCE 1
: Cut with sequence 1.
(15) Special mode for the custom paper selected [Initial value: MODE 0]
Set a special mode for the custom paper selected.
<Parameter (Enter a choice)>
MODE 0 : Print in NORMAL mode. Print with the print mode
designeted by computer or network controller.
MODE 1 : Print in high density mode instead of 8P mode in
HQ PRINT menu.
- Engine-SCSI firmware version 2.xx or former:
Print in high density 8-pass mode.
- Engine-SCSI firmware version 3.00 or later:
Print in the mode selected in HD PRINT menu.
(16) Delete of the custom paper (C_PAPER DELETE)
Delete a custom paper registered.
<Parameter (Enter a choice)>
Number of the custom paper: 01 to 10