Segway i2 SE, Service Manual

Page: 62 / 92

Segway Personal Transporter SE Service Manual 9–10
Console
Front Light Pipe
Removal
Tool Required: T-10 6-lobe wrench
1. Make sure the PT is powered off, unplugged, and the
batteries have been removed.
2. Establish a Serviceable Powerbase ( page 8–2 ).
3. Remove the Radio Board ( page 9–3 ).
4. Detach the Console from the Powerbase
( page 9–4 ).
5. Remove the Power Board ( page 9–5 ).
6. Remove the Interconnect Board ( page 9–6 ).
7. Remove the Pivot Assembly ( page 9–9 ).
8. Using a T-10 6-lobe wrench, remove the two
fasteners holding the Light Pipe in place. Discard the
fasteners. See
Figure 9–13 .
Installation
Tools Required: T-10 6-lobe wrench
Torque wrench
1. Slide the gasket onto the Light Pipe with
the adhesive side toward the Light Pipe. See
Figure 9–13 .
2. Orient the Light Pipe on the Console Base.
3. Using a T-10 6-lobe wrench, install the two fasteners.
Torque to 1.6 N-m (14 in-lbf) .
NOTICE
Original fasteners are self-tapping. Replace with
non-tapping fasteners.
4. Install the Pivot Assembly ( page 9–9 ).
5. Install the Interconnect Board ( page 9–6 ).
6. Install the Power Board ( page 9–5 ).
7. Install the Console onto the Powerbase
( page 9–4 ).
8. Install the Radio Board ( page 9–3 ).
9. Reassemble the PT from the Serviceable Powerbase
( page 8–2 ).
10. Perform post-service tests ( page A–1 ).
Figure 9–13: Front Light Pipe
Front Light Pipe
20566-00001 (self-tapping)
20972-00001 (non-tapping)
1.6 N-m (14 in-lbf)
Gasket
Console Base