Segway i2 SE, Service Manual

Page: 43 / 92

Segway Personal Transporter SE Service Manual 6–3
Powerbase Trim
Console Cover
Removal
Tools Required: 4 mm hex wrench
T-20 6-lobe wrench
1. Make sure the PT is powered off and unplugged.
2. Using a 4 mm hex wrench, remove the two fasteners
from the Front Console Cover and slide the Front
Console Cover off. See
Figure 6–2 .
3. Using a T-20 6-lobe wrench, remove the four
fasteners on the Center Console Cover and lift the
Center Console Cover off. See
Figure 6–3 .
CAUTION!
Make sure the IEC connector (charge port) remains
clean and dry.
Installation
Tools Required: T-20 6-lobe wrench
4 mm hex wrench
Torque wrench
1. Make sure the PT is powered off and unplugged.
2. Place the Center Console Cover on the console.
3. Using a T-20 6-lobe wrench, install the four
fasteners. Torque to 1.5 N-m (13 in-lbf) .
See Figure 6–3 .
4. Slide the Front Console Cover over the legs of the
Center Console Cover.
5. Using a 4 mm hex wrench, install the two fasteners.
Torque to 1.5 N-m (13 in-lbf) . See Figure 6–2 .
6. Perform post-service tests ( page A–1 ).
Figure 6–2: Front Console Cover
Figure 6–3: Center Console Cover
Center Console Cover
Center Console Cover
20307-00002
1.5 N-m (13 in-lbf)
Front Console Cover
20554-00001
1.5 N-m (13 in-lbf)