Segway i2 SE, Service Manual

Page: 20 / 92

Segway Personal Transporter SE Service Manual 1–6
LeanSteer Stem
Removal
Tool Required: T-30 6-lobe wrench
1. Make sure the PT is powered off and unplugged.
2. Remove the LeanSteer Stem Cap (see
Figure 1–7 ).
3. Using a T-30 6-lobe wrench, remove the four
fasteners.
4. Slide the LeanSteer Stem off the pivot base.
Installation
Tools Required: T-30 6-lobe wrench
Torque wrench
1. Make sure the PT is powered off and unplugged.
2. Slide the LeanSteer Stem onto the pivot base (see
Figure 1–7 ).
NOTICE
The Standard LeanSteer Stem must be used
with the Standard LeanSteer Frame, and the
Patroller LeanSteer Stem must be used with the
Patroller LeanSteer Frame. Standard and Patroller
components cannot be used together.
3. Using a T-30 6-lobe wrench, install the four
fasteners, but do not tighten completely.
4. Make sure the LeanSteer Stem is vertical.
5. Tighten the fasteners to
11 N-m (8.1 ft-lbf) .
6. Verify that the LeanSteer Stem is still vertical.
7. Place the LeanSteer Stem Cap over the front of the
LeanSteer Stem and press until it snaps in place.
8. Perform post-service tests ( page A–1 ).
Figure 1–7: LeanSteer Stem
Pivot Base
LeanSteer Stem
20539-00001
11 N-m (8.1 ft-lbf)
LeanSteer
Stem Cap
LeanSteer
Figure 1–8: LeanSteer Stem Comparison
Standard Patroller