Segway i2 SE, Service Manual

Page: 32 / 92

Segway Personal Transporter SE Service Manual 4–4
Tire/Wheel Assembly
x2 SE Turf Wheel Assembly
Removal
Tools Required: 8 mm hex wrench
Rubber mallet
1. Make sure the PT is powered off and unplugged.
2. Support the PT or turn it on its side.
3. If removing the x2 SE Turf Wheel Assembly and Hub
Adapter, proceed to page 4–5 .
4. Using an 8 mm hex wrench, remove the four
fasteners. See Figure 4–3 .
5. Lift off the wheel trim.
6. Loosen the x2 SE Turf Wheel Assembly by tapping
the side of the wheel with a rubber mallet.
7. Lift off the x2 SE TurfWheel Assembly, including the
spacer.
Installation
Tools Required: Isopropyl alcohol wipes
8 mm hex wrench
Torque wrench
1. Make sure the PT is powered off and unplugged.
2. Support the PT or turn it on its side.
3. Inspect the wheel mounting surfaces; use isopropyl
alcohol wipes to clean off all debris.
4. Place the Spacer over the hub adapter; align the
mounting holes. See Figure 4–3 .
5. Place the Wheel against the Spacer, with the valve
stem facing outward; align the mounting holes.
6. Place the wheel trim on the Wheel; align the
mounting holes.
7. Insert four fasteners through the wheel trim, Wheel,
and Spacer. Using an 8 mm hex wrench, thread the
fasteners into the Hub Adapter. Torque to
35 N-m
(26 ft-lbf) .
8. Perform post-service tests ( page A–1 ).
Figure 4–3: x2 SE Turf Tire/Wheel Assembly
x2 Turf Wheel
Wheel
Trim
20991-00002
35 N-m (26 ft-lbf)
Spacer
Hub Adapter