Segway i2 SE, Service Manual

Page: 22 / 92

Segway Personal Transporter SE Service Manual 1–8
InfoKey Controller Battery
Removal
Tool Required: Coin or flathead screwdriver
1. Make sure the PT is powered off and unplugged.
2. Rotate the InfoKey Controller 45 degrees
counterclockwise to separate it from the InfoKey
Dock Adapter. See
Figure 1–11 .
3. Using a coin or a flathead screwdriver, unscrew the
back cover of the InfoKey Controller and remove the
battery. See
Figure 1–12 .
Installation
Tool Required: Coin or flathead screwdriver
1. Make sure the PT is powered off and unplugged.
2. Verify that the new battery is type CR2430, available
as part of the Segway InfoKey Kit.
3. Insert the InfoKey Controller Battery with the
positive (+) side showing. See Figure 1–12 .
4. Using a coin or flathead screwdriver, reattach the
back cover of the InfoKey Controller.
5. Place the InfoKey Controller on the InfoKey Dock
Adapter and rotate clockwise until the InfoKey
Controller clicks into position. See
Figure 1–11 .
6. Perform post-service tests ( page A–1 ).
Figure 1–11: Connect/Disconnect InfoKey Controller to Dock Adapter
Figure 1–12: InfoKey Controller Battery
LeanSteer