Segway i2 SE, Service Manual

Page: 44 / 92

Segway Personal Transporter SE Service Manual 6–4
Powerbase Trim
Front and Rear Fascia
Removal and installation instructions are identical for both
front and rear fascia.
Removal
Tool Required: 4 mm hex wrench
1. Make sure the PT is powered off and unplugged.
2. Remove one Tire/Wheel Assembly.
− i2 SE ( page 4–2 )
− x2 SE ( page 4–3 )
− x2 SE Turf ( page 4–4 )
3. Remove both fenders.
− i2 SE Fenders ( page 5–2 )
− x2 SE Fender Frames ( page 5–4 )
4. Remove the Console Cover ( page 6–3 ).
5. Using a 4 mm hex wrench, remove the two fasteners
holding the Fascia. See Figure 6–4 and Figure 6–5 .
6. Remove the Fascia.
Installation
Tools Required: 4 mm hex wrench
Torque wrench
1. Make sure the PT is powered off and unplugged.
2. Place the front Fascia onto the front of the
powerbase ( Figure 6–5 ) and the rear Fascia onto
the rear of the powerbase ( Figure 6–4 ).
3. Using a 4 mm hex wrench, install the four fasteners.
Torque to 1.5 N-m (13 in-lbf) .
4. Install the Console Cover ( page 6–3 ).
5. Install the Fenders.
− i2 SE ( page 5–2 )
− x2 SE ( page 5–4 )
6. Install the Tire/Wheel Assembly.
− i2 SE ( page 4–2 )
− x2 SE ( page 4–3 )
− x2 SE Turf ( page 4–4 )
7. Perform post-service tests ( page A–1 ).
Figure 6–4: Rear Fascia
Figure 6–5: Front Fascia
Front Fascia
20554-00001
1.5 N-m (13 in-lbf)
Rear Fascia
20554-00001
1.5 N-m (13 in-lbf)