Segway i2 SE, Service Manual

Page: 40 / 92

Segway Personal Transporter SE Service Manual 5–4
Fenders
x2 SE Fender Frame
Removal
Tool Required: 4 mm hex wrench
1. Make sure the PT is powered off and unplugged.
2. Remove the Tire/Wheel Assembly (
page 4–3 ).
3. Remove the Fender ( page 5–3 ).
4. Using a 4 mm hex wrench, remove the three
fasteners holding the Fender Frame to the gearbox.
See
Figure 5–3 . Discard the fasteners.
5. Remove the Fender Frame.
NOTICE
The Fender and Fender Frame can be removed as a
unit (not shown). Fender Frame fasteners should be
discard and replaced with new ones.
Installation
Tools Required: 4 mm hex wrench
Torque wrench
1. Make sure the PT is powered off and unplugged.
2. Place the Fender Frame on the Gearbox.
See Figure 5–3 .
3. Using a 4 mm hex wrench, install three new Fender
Frame fasteners. Torque to 6.0 N-m (4.5 ft-lbf) .
4. Install the Fender ( page 5–3 ).
5. Install the Tire/Wheel Assembly ( page 4–3 ).
6. Perform post-service tests ( page A–1 ).
Fender Frame
Gearbox
20553-00002
6.0 N-m (4.5 ft-lbf)
Figure 5–3: x2 SE Fender Frame