PRECAUTIONS WHEN MOVING THE MACHINE
Ground the casters and move the product.
Always remove the pedal unit.
PRECAUTIONS WHEN MOVING THE MACHINE
• Always disconnect the power cable before moving the product. If it is moved
with the power cable connected, the cable could be damaged, causing fire or
electric shock.
• To move the unit over the floor, pull in the adjustors and have the casters
contact the floor. While moving the unit, be careful that the casters do not roll
over the power cord or the ground wire. If cord or wire is damaged, there could
be electrical shocks and/or short circuits.
• To lift up the cabinet, hold it at the bottom. If you hold it anywhere else, the
weight of the cabinet could cause damage to parts or attachments, resulting in
injury.
• To install this product, the entrance must be at least 1.7 m (5.6 ft) in width and
2.2 m (7.2 ft) in height. If the entrance is too narrow, do not tilt the product
carelessly. If all the product weight is put on the casters at one side only, there
could be damages or deformations, causing serious accidents such as workers
getting caught underneath.
• If the unit cannot be taken through the entrance, do not disassemble it
indiscriminately. Do not disassemble the unit in any way other than as instructed
in this manual. Indiscriminate disassembly could result in electrical shocks, short
circuits, or accidents while working on or operating the unit, leading to injuries.
• Do not hold or press the plastic parts as indicated by the figure. Failure to
observe this instruction may break the parts, and eventually the broken pieces
may cause a personal injury.
• Remove the pedal unit. It is very difficult to move the product while the pedal
unit is attached. Failure to remove it could cause an accident. Parts could also
become damaged or deformed, and the floor surface could be damaged.
FIG. 7a
If there are level differences at the installation site,
detach both sides of the tube and then detach the
front cabinet and rear cabinet before moving.
Summary of Contents for 2SPICY
