Sega 2SPICY, Owner'S Manual

Page: 35 / 150

0
ASSEMBL
Y AND INST
ALLA
TION
ENGAGEMENT OF POWER SUPPLY AND SOFTWARE INSTALLATION
• Be careful not to damage the DVD wire by getting it caught between objects,
etc. Doing so may cause a short circuit or fire.
• The following explanation assumes that the product has been assembled
properly as explained above. If there is an error or if the product operates in a
manner other than as indicated below, cut off the power supply immediately.
Failure to do so may result in a fire or electrical shock.
• If you look directly at the laser beam in the DVD DRIVE, you could suffer vision
impairment. Do not look inside the DVD DRIVE.
• The software is not installed on the game board (LINDBERGH RED) when the
power supply is engaged, so the “Error 22” message is not a malfunction.
However, if there is another error display, or if there is no video output at all,
there might have been an error in product assembly, wiring connections might
be faulty, or the LINDBERGH RED might not be functioning properly.
• After the power supply is engaged, wait for “Error 22” message to be displayed.
If the product is indiscriminately operated in any way beforehand, there could
be unexpected problems or malfunctions, as well as damage to parts.
• Once “Error 22” is displayed, set the DVD-ROM in the DVD DRIVE and re-engage
the power supply. Installation takes place.
• After the power supply is engaged, the DVD DRIVE tray will not come out
for about 30 seconds even if you press the switch. This is due to DVD DRIVE
initialization.
• The DVD DRIVE tray can come out or return only while the power supply is
engaged. The tray cannot be opened or closed while the power is off.
• Even after the software has been installed, store the DVD software kit, DVD DRIVE
and DVD wire in a secure location.
• If for any reason installation cannot be completed, an error is displayed. Refer
to the service manual and take corrective action.
Prepare the DVD DRIVE kit (sold separately). (See Table 5c.)
Use the DVD wire (2 m) included with this product, and not the wire included with the DVD DRIVE kit.
Turn the main switch of the AC unit to ON and engage the power supply.
The LINDBERGH RED Startup Screen appears. Wait for at least one minute. The error state is established.
Check to be sure it is “Error 22.” If it is “Error 22,” proceed to the next operation. If it is not “Error 22,”
refer to the LINDBERGH RED Service Manual and take corrective action.