Sega 2SPICY, Owner'S Manual

Page: 73 / 150

CONTROL
UNIT (GUN)
0
Microswitch Replacement
Three kinds of screws are used to fasten the L and R covers. The L and R covers can be detached by
removing all ten of these screws.
With the R cover on the bottom, remove the L cover by slowly lifting it straight up.
Remove the trigger microswitch from the R
cover.
Remove the soldered part and then remove the microswitch.
Solder the new microswitch. Employ heat shrinkable tubing to protect the soldered part. Reassemble the
gun. Operate the trigger to fully verify that the microswitch turns on and off properly. Then, reattach the L
cover to the R cover. Do not tighten the screws excessively.
After replacing the microswitch, refer to the section titled “GAME TEST MODE”. Conduct an Input Test.
COUNTERSUNAK-HEAD SCREW (1), black
M3 x 8
SCREW (8), black
M3 x 12, w/ small flat & spring washers
SCREW (1), black
M3 x 10, w/ small flat & spring washers
MICROSWITCH
509-5080
FIG. 10a
FIG. 10b