Sega 2SPICY, Owner'S Manual

Page: 72 / 150

CONTROL
UNIT (GUN)
0
CONTROL UNIT (GUN)
0
• When working with the product, be sure to turn the power off. Working with the
power on may cause an electric shock or short circuit.
• Be careful not to damage the wires. Damaged wires may cause an electric
shock, short circuit or present a risk of fire.
• Exercise due caution in performing soldering work. If soldering iron is handled
carelessly, there could be fires or burns.
• When fastening plastic parts, be careful not to tighten screws or nuts excessively.
If these are tightened to excess, parts could be damaged, resulting in injuries
from fragments, etc.
• After the unit has been disassembled and reassembled again, check carefully
to be sure that there are no gaps or rattling at the junctions and that the trigger
can be operated smoothly. If there are gaps or rattling, or if operation is not
satisfactory, the players could get fingers or hands caught, resulting in injury.
• Be sure to inspect gun surfaces for cracks and damage. Players could be
injured if they play when the unit is cracked or damaged.
• Assemble so that there is no gap between the L and R covers. If there is a gap
or rattling, the players could get fingers or hands caught, resulting in injury.
• Once the product has been disassembled, use slack preventive agent (product
No. : 090-0012-N). Coat screws with suitable amounts of this agent and then
tighten them. If this agent is not used, the product might start rattling or come
apart.
• Use the slack preventive agent prescribed in these instructions. If any other
agent is used, there could be chemical changes that inhibit the use of screws
and part surfaces could be damaged.
• Be careful not to damage or lose small parts or screws.
• When a part has been replaced, be sure to always make adjustments and
check conditions in Test Mode.
If the gun does not operate satisfactorily and adjustments in Test Mode are ineffective, it could be that parts inside
the gun have been damaged.
Follow the steps given below to remove the gun, then take it apart and replace parts.
To replace parts in the gun, detach the L and R covers of the outer part.
Because internal parts are inserted on the R cover side, work with the R cover facing downward.