Step 5 — Artemis Contents Unpacked
These are the parts that make up the Artemis 300.
Step 6 — Z Tower
There are 3 towers for the Artemis. 1
of the towers has the extruder and
hot end whip pre-installed. For this
step you can choose either of the
remaining 2 towers to be the Z
tower.
Locate the Z Tower Wire pack.
Remove the wires from the pack and
straighten them out. Be careful not
to lose any of the connectors from
the pack.
The connectors shown will be in the
top of the machine (the side with the
stepper motors).
Please make sure you have the
wires in the orientation shown.
Assembling Artemis 300
© 2018
seemecnc.dozuki.com/
Page 6 of 40
