Step 51 — Install the Base Cover
You will now re-install the base cover. Before doing so, make sure all wires are secured and not
going to interfere with its installation. If you find a loose wire, use a zip tie to secure it to a piece of
T-Slot.
Most Artemis 300s were shipped with Removable Plastic Rivets. These easily press in and secure
the sheet metal enclosure (and are easily removable for future needs)
Remember, if your sheet metal enclosure is secured with screws, DO NOT use power tools to
tighten the cover screws!
Step 52 — Installing the Top Cover
Most Artemis 300s were shipped with Removable Plastic Rivets. These easily press in and secure
the sheet metal enclosure (and are easily removable for future needs)
The top cover has a fan installed. This fan should be plugged into an ALWAYS ON FAN terminal
on the DUET board. This is highlighted in the photo.
After you have plugged in the fan, slide the cover down onto the top of the printer and secure with
the 6 removable plastic rivets or tighten the 6 screws. Remember, NO POWER TOOLS!
Assembling Artemis 300
© 2018
seemecnc.dozuki.com/
Page 39 of 40
