Sea-doo Challenger 5896, Shop Manual

Page: 212 / 274

Section 09 PROPULSION AND DRIVE SYSTEMS
Sub-Section 01 (PROPULSION AND DRIVE SYSTEMS)
09-01-9
1. Impeller remover installer tool
2. Impeller shaft holder tool
CAUTION : Never use any impact wrench
to loosen impeller.
To remove impeller, apply a rotating movement
and pull at same time. Slide impeller out of hous-
ing and remove tool from impeller.
Remove 2 screws holding impeller housing to
shaft holder.
Lift impeller housing away from impeller shaft.
Slide thrust washer and thrust bearing off from
shaft.
20, Wear Ring
Place impeller housing in a brass jaw vise so that
it is firmly retained by a lug.
Cut wear ring at 2 adjacent places.
NOTE : Wear ring can be cut using a jigsaw,
a small buffer or a low clearance hacksaw
such as Snap-on HS3 or equivalent.
CAUTION : When cutting ring, be careful
not to damage impeller housing.
TYPICAL
1. Snap-on HS3
After cutting ring, insert a screwdriver blade be-
tween impeller housing and one end of ring.
Lift ring end so that both ends overlap each other.
Pull ring out.
21, Seal
To remove seal, proceed as follows :
CAUTION : It is not recommended to
push seal out with a punch. Housing and
/ or bearing(s) could be damaged.
Seal should be removed using the following sug-
gested tool.
Seal puller, Snap-on no. S6129.
F01J2HA
1
2
-
'
-
F01J0VA
F01J0WA
1
-