Sea-doo 2003 GTI LE RFI, Shop Manual

Page: 564 / 779

Section 12 ELECTRICAL SYSTEM
Subsection 05 (INSTRUMENTS AND ACCESSORIES)
SMR2003-038_12_05A.FM
12-05-7
Compass: Displays the cardinal points to indicate
the orientation of the watercraft.
Average Speed: The information center approxi-
mately calculates and displays the average speed
(AV KM/H or AV MPH) of the watercraft since the
last engine start.
Distance (KM or MILES) . The information center
approximately calculates the distance based on the
operation time and the watercraft speed and dis-
plays the result in kilometers (KM) or miles (MILES).
Hourmeter: Displays the time in hours of the wa-
tercraft usage (HOUR).
Water Temperature: Displays the water temper-
ature of the water surface (L TEMP) in degrees
Celsius (°C) or Fahrenheit (°F).
Exterior Temperature: Displays the exterior air
temperature (E TEMP) in degrees Celsius (°C) or
Fahrenheit (°F).
Trip Hour Meter: (TRIPMTR) Allows to measure an
interval of time in hours and minutes (hh:mm).
Function Buttons
Different displays and functions can be activated
using 2 buttons — MODE and SET — following
specific sequences as described below.
1. To change display mode
2. To set or reset a function
Resetting a Function
To reset a function (such as the trip hour meter, dis-
tance, etc.) press and hold the SET button for 2 sec-
onds while in the appropriate mode.
Display Selection
Repeatedly pressing the MODE button scrolls the
following displays: Compass, tachometer, speed-
ometer, average speed, distance, hourmeter, water
temperature, exterior temperature, depth gauge (
if
so equipped ), and trip hour meter.
1. Press to change display mode
When you are satisfied with your choice, stop press-
ing the button and it will become active. The display
you have chosen will remain until it is changed.
Display Priorities
As a self test at start-up, the needles of the speed-
ometer and tachometer will sweep to their maxi-
mum position, all LCD segments and the LED will
turn on for 3 seconds each time the information cen-
ter is activated (when safety lanyard is installed).
This allows the driver to validate they are all working
properly.
When the information center is activated, the last
function set will be displayed.
In the event of a warning message, the message
will blink and override the units display unless
MODE button is pressed. The display will then dis-
play the last function after 10 seconds.
If more than one warning message occurs, the
blinking messages will scroll every 4 seconds.

WARNING
Use the compass as a guide only. Not to be
used for navigation purposes.
F18L09B
1 2
F18L09C
1
www.SeaDooManuals.net