Sea-doo 2003 GTI LE RFI, Shop Manual

Page: 714 / 779

Section 16 HULL/BODY
Subsection 02 (ADJUSTMENT AND REPAIR)
SMR2003-046_16_02A.FM
16-02-29
ACCESS PANEL ADJUSTMENT
XP DI Models
Adjust lock pin no. 3 of access panel as per follow-
ing specifications:
1. Lock pin
2. Adjustment nut (Loctite 243)
3. Lock nut. Torque to 5 N•m (44 lbf•
in )
A. 39 ± 1 mm (1-17/32 ± 3/64 in)
Adjust bolts no. 16 of access panel arms as per
following specifications:
1. Lock nut. Torque to 22 N•m (16 lbf•ft)
A. 20 ± 1 mm (25/32 ± 3/64 in)
MIRROR
GTI LE and RX DI
Place the mirror frame in hot water to “soften” the
material to allow mirror installation in its frame.
GTX 4-TEC Series and GTX DI
Removal and Installation
To remove mirror proceed as follows:
– Remove storage compartment inner shell from
storage cover as described earlier in this sec-
tion.
– Remove two hexagonal screws and flat wash-
ers.
– Remove defective mirror with a spatula.
1. Mirror
2. Spatula
– Place the mirror frame in hot water to “soften”
the material to allow mirror installation in its
frame.
– Reinstall storage compartment inner shell.
INFO CENTER (LCD gauges)
GTX DI
Info gauges can be pulled directly out from the
storage cover.
GTX 4-TEC
Removal and Installation
To remove the Info center (Speedometer and LCD
Info gauge) proceed as follows:
– Carefully pull each side of the Info Center (LCD
Gauges) using a suction cup (P/N 295 000 163)
to remove Info Center from the storage cover.
F08L1BA
1
2
3
A
F05L0VA
A
1
1
F18L21A
2
www.SeaDooManuals.net