Sea-doo 2003 GTI LE RFI, Shop Manual

Page: 561 / 779

Section 12 ELECTRICAL SYSTEM
Subsection 05 (INSTRUMENTS AND ACCESSORIES)
12-05-4
SMR2003-038_12_05A.FM
Tachometer: Indicates the revolutions per minute
(RPM) of the engine.
Speedometer: Indicates the speed of watercraft
in kilometers per hour (KPH) or miles per hour
(MPH).
Average Speed: The information center approxi-
mately calculates and displays the average speed
(AV KPH or AV MPH) of the watercraft since the
last engine start.
Trip Meter: The information center approximately
calculates the distance based on the operation time
and the watercraft speed and displays the result in
kilometers (KM) or miles (MILES).
Hourmeter: Displays the time in hours of the wa-
tercraft usage.
Water Temperature: Displays the water tempera-
ture of the water surface (L TEMP) in degrees Cel-
sius (°C) or Fahrenheit (°F).
Exterior Temperature ( if so equipped ): Displays
the exterior air temperature (E TEMP) in degrees
Celsius (°C) or Fahrenheit (°F).
Chronometer: Allows to measure an interval of
time in hours and minutes (hh:mm).
Message Display
The information center features a display area that
blinks a message whenever one of the following
circumstances occurs:
• fuel injection system sensors and major compo-
nents (MAINT) ( DI models )
• compass error (COMPAS) ( if so equipped )
• maintenance (MAINT)
• engine overheating (H-TEMP)
• low fuel (FUEL-LO)
• low oil (OIL LOW)
• low voltage (12 V LOW).
A buzzer will sound when one of the four last cir-
cumstances occurs.
Except for low fuel and low oil, which can be correct-
ed by refilling, it is recommended to see an autho-
rized SEA-DOO dealer when other messages occur.
The warning light will blink at the same time.
Warning Light
The red warning LED (Light-Emitting Diode) blinks
along with the message display to catch your at-
tention.
Fuel Level Display
Bar gauge continuously indicates the amount of
fuel in the fuel tank while riding. A low-fuel condi-
tion is also indicated when it occurs. See MES-
SAGE DISPLAY above.
VTS Position Indicator ( if so equipped )
The VTS position indicator shows the riding angle
of the watercraft.
1. Position indicator
2. Bow up
3. Bow down
Display Priorities
As a self test, all LCD segments and the LED will
turn on for 3 seconds each time the information cen-
ter is activated (when safety lanyard is installed).
When the information center is activated, the last
function set will be displayed if it was the tachom-
eter, speedometer or chronometer. If another func-
tion was set, the compass will be displayed.
On
models without the compass function, the word
“SeaDoo” will be displayed.
In the event of a warning message, the message
will blink and override the units display.
If more than one warning message occurs, the
blinking messages will scroll every 4 seconds.
F00L2DA
1
2
3
www.SeaDooManuals.net