SCHOTTEL SV 1, Manual

Page: 139 / 156

en
31 /
Control System and Electric System (PX 105) FIT--Wa 1159850 Dec./06
48
Take--over from the chair control stand board
to the main control stand board
The following required conditions are to be met:
D
The signal lamp ”ARM CHAIRS” (33/3) on the main
control stand board shines.
D
Illuminated push--button ”DESK ON” (34/3) on the
active chair control stand board shines.
D
Signal lamp ”ARM CHAIR ... IN SERVICE” (34/2)
on the non--active chair control stand board
shines.
The change from the chair control stand board to the
board of the main control stand is carried out as follows:
1. Press illuminated push--button ”DESK ON” (33/4)
on the main control stand board.
The horn (34/1) on the active chair control stand
board sounds for 5 s and the illuminated
push--button ”DESK ON” on the main control stand
board shines.
Illuminated push--button ”DESK ON” (34/3) on the
active chair control stand board goes out.
Illuminated push--button ”ARM CHAIR ... IN
SERVICE” (34/2) on the non--active chair control
stand board goes out.
The signal lamp ”ARM CHAIRS” (33/3) on the main
control stand board goes out.
2. Signal lamp ”RPM” (33/2) on the main control
stand board flashes.
Set speed lever on the Co--pilot to the actual
speed.
Signal lamp ”RPM” on the main control stand
board shines.
3. Signal lamp ”Presetting thrust direction” (33/1) on
the main control stand board flashes.
Turn the control block of the Co--pilot to the actual
thrust direction.
Signal lamp ”Presetting thrust direction” (33/1) on
the main control stand board shines.
RPM
RPM
EMERG
STOP
POWER
MODE
STOP
DRIVE
MOTOR
RESET
FAULT
POWER
LIMIT
DESK
ON
ARM
CHAIRS
ECR
DESK
SEND
TO ECR
LOCAL
CONTROL
FU
RUNNING
START
DRIVE
MOTOR
ON
PILOT
OFF
PILOT
ON
IN SERVICE
2
1
4 3
Figure 33
1
2
STOP
DRIVE
MOTOR
RESET
FAULT
POWER
LIMIT
DESK
ON
ARMCHAIR
PS
ECR
DESK
SEND
TO ECR
LOCAL
CONTROL
FU
RUNNING
START
DRIVE
MOTOR
ON
IN SERVICE
RPM
RPM
EMERG
STOP
POWER
MODE
ON
PILOT
IN SERVICE
3
Figure 34