SCHOTTEL SV 1, Manual

Page: 123 / 156

en
15 /
Control System and Electric System (PX 105) FIT--Wa 1159850 Dec./06
48
Operating and display elements, main control stand board
Pos. Operating or display element Function
1 Thrust direction indicator The red tip in the pointer of the thrust direction indicator shows the ac-
tive thrust direction of the system.
Also see chapter ”Examples for Steering Manoeuvres”.
2 Signal lamp DP JOYSTICK IN
SERVICE (green)
Signal lamp shines with the system controlled by DP or joystick system.
3 Dimmer The dimmer is used for adjusting the brightness of the illuminated
push--buttons and signal lamps.
4 Push--button TEST (white) Pressing the push--button will start a lamp test of the signal lamps and
illuminated push--buttons.
All signal lamps and illuminated push--buttons must shine (except
TEST and PILOT OFF).
5 Illuminated push--button ON (yel-
low) with protective cap
Pressing the illuminated push--button will connect the time--depen-
dent controls.
6 Speed indicator The speed indicator shows the actual propeller speed of the system
in revolutions per minute (rpm).
7 Signal lamp RPM (green) Signal lamp shines with the path--dependent speed regulation is ac-
tive via the Co--pilot.
8 Illuminated push--button RPM
#
(yellow)
Pressing the illuminated push--button reduces the operating speed of
the system as long as it push--button is pressed.
Shines with the main control stand board active.
9 Illuminated push--button RPM
"
(yellow)
Pressing the illuminated push--button increases the operating speed
of the system as long as it is pressed.
Shines with the main control stand board active.
10 Signal lamp FU ALARM (red) Signal lamp shines with alarm from the frequency converter.
11 Illuminated push--button POWER
MODE (green)
Pressing the illuminated push--button changes the frequency conver-
ter from SPEED CONTROL to POWER CONTROL.
12 Contact EMERG STOP (red) with
protective cap
Pressing the illuminated push--button sends an emergency stop com-
mand to the controls of the driving motor. Shines after pressing.
The illuminated push--button is always active, independent from the
active control stand.
13 Horn Sends an audible signal for backing visual signals and signals deve-
lopments in the control process.
14 Signal lamp POWER LIMIT (red) Signal lamp shines when reaching the speed limit of the system.
15 Signal lamp FU RUNNING (green) Signal lamp shines with the frequency converter in operation.
16 Illuminated push--button START
DRIVE MOTOR (green)
Pressing the illuminated push--button activates the frequency conver-
ter of the driving motor.
Shines with the frequency converter ready for service.
17 Illuminated puch--button STOP
DRIVE MOTOR (red) with protec-
tive cap
Pressing the illuminated push--button switches the frequency conver-
ter off.
Shines with the frequency converter switched off.