SCHOTTEL SV 1, Manual

Page: 140 / 156

32 / 48
Control System and Electric System (PX 105) FIT--Wa 1159850 Dec./06 en
Take--over from the main control stand board
to the chair control stand board
The change from the main control stand board to the
board of the chair control stand is carried out as follows:
1. Press illuminated touch contact ”DESK ON” (35/4)
on the according chair control stand board.
The horn (36/1) on the main control stand board
sounds for 5 s and the illuminated push--button
”DESK ON” (35/3) on the active chair control stand
board shines.
Signal lamp ”ARM CHAIR ... IN SERVICE” (35/4)
on the non--active chair control stand board
shines.
2. Signal lamp ”RPM” (35/1) on the chair control
stand board flashes.
Set speed lever on the control lever to the actual
speed.
Signal lamp ”RPM” on the chair control stand
board shines.
3. Signal lamp ”Presetting thrust direction” (35/2) on
the chair control stand board flashes.
Turn the control block of the control lever to the
actual thrust direction.
Signal lamp ”Presetting thrust direction” on the
chair control stand board shines.
3 4
STOP
DRIVE
MOTOR
RESET
FAULT
POWER
LIMIT
DESK
ON
ARMCHAIR
PS
ECR
DESK
SEND
TO ECR
LOCAL
CONTROL
FU
RUNNING
START
DRIVE
MOTOR
ON
IN SERVICE
RPM
RPM
EMERG
STOP
POWER
MODE
ON
PILOT
IN SERVICE
1
2
Figure 35
RPM
RPM
EMERG
STOP
POWER
MODE
STOP
DRIVE
MOTOR
RESET
FAULT
POWER
LIMIT
DESK
ON
ARM
CHAIRS
ECR
DESK
SEND
TO ECR
LOCAL
CONTROL
FU
RUNNING
START
DRIVE
MOTOR
ON
PILOT
OFF
PILOT
ON
IN SERVICE
1
Figure 36