SCHOTTEL SV 1, Manual

Page: 137 / 156

en
29 /
Control System and Electric System (PX 105) FIT--Wa 1159850 Dec./06
48
Take--over from the engine room board to the
main control stand board
The change from the engine room board to the board
of the main control stand is carried out as follows:
1. Press illuminated push--button ”SEND TO
BRIDGE” (29/2) on the engine room board.
Illuminated touch contact ”DESK ON” (30/3) on the
main control stand board flashes.
RPM
EMERG
STOP
POWER
MODE
STOP
DRIVE
MOTOR
RESET
FAULT
POWER
LIMIT
DESK
ON
MAIN
DESK
SEND
TO BRIDGE
LOCAL
CONTROL
FU
RUNNING
START
DRIVE
MOTOR
ARM
CHAIRS
1
2 3
Figure 29
2. Press illuminated push--button ”DESK ON” on the
main control stand board.
Illuminated push--button ”DESK ON” shines.
The signal lamp ”ECR DESK IN SERVICE” (30/2)
on the main control stand board goes out.
The illuminated push--button ”MAIN DESK” (29/1)
on the engine room board shines.
Take--over from the main control stand board
to the engine room board
The change from the main control stand board to the
board of the engine room is carried out as follows:
1
RPM
RPM
EMERG
STOP
POWER
MODE
STOP
DRIVE
MOTOR
RESET
FAULT
POWER
LIMIT
DESK
ON
ARM
CHAIRS
ECR
DESK
SEND
TO ECR
LOCAL
CONTROL
FU
RUNNING
START
DRIVE
MOTOR
ON
PILOT
OFF
PILOT
ON
IN SERVICE
2
3
Figure 30
1. Press illuminated push--button ”SEND TO ECR”
(30/1) on the main control stand board.
Illuminated touch contact ”DESK ON” (29/3) on the
engine room board flashes.
2. Press illuminated push--button ”DESK ON” on the
engine room board.
Illuminated push--button ”DESK ON” on the engine
room board shines.
The signal lamp ”ECR DESK IN SERVICE” (30/2)
on the main control stand board shines.