SATELLINE-EASy Pro 35W
User Guide v.1.4
52
Now all of the modifications of the example have been performed and the new values are
displayed on the menu as follows:
***** SATELLINE *****
FW: 06.18.x.xx / HW: SEPT / PV: 05.00 / IM: 05 / /N: YYMMxxxx
-------------------------------------------------------------------------------
Current settings
----------------
1) Radio frequency TX: 438.00000 MHz / RX: 450.00000 MHz /
Ref freq: 438.00000 MHz / Spacing 20kHz
2) Radio settings TX power 35W / Signal threshold -118 dBm / FCS OFF /
TX start delay 0ms / Compatibility Satel 3AS / Call sign OFF
3) Addressing RX address OFF / TX address OFF /
RX address to RS port OFF / TX address autoswitch OFF
4) Serial port 1 ON / 9600 bit/s / 8 bit data / None parity /
1 stop bit
5) Serial port 2 OFF / 9600 bit/s / 8 bit data / None parity /
1 stop bit ( TTL )
6) Handshaking CTS TX buffer state / CD Data on channel /
RTS Flow control / Pause length 3 bytes
7) Additional setup Error correction OFF / Error check OFF / Repeater OFF /
SL-commands ON / Priority TX / Full CRC16 check OFF /
User Data whitening OFF
8) Routing OFF
9) Tests OFF
A) Restore factory settings
B) Info
E) EXIT and save settings
Q) QUIT without saving
Enter selection >
9.2.11
Special functions
Special functions are modified by selecting from the main menu selection ”7”. The current values
of the parameters are displayed and can be modified in toggle-type fashion by choosing the
appropriate parameter selection number from the list displayed. The next menu level will then
enable the modification of the values (within allowed limits).
Number 7 is pressed in the Main menu.
Additional setup
Toggle ON/OFF values. Current value shown.
------------------------------------------
1) Error correction OFF
2) Error check OFF
3) Repeater OFF
4) SL-commands ON
5) Priority TX
6) Full CRC16 check OFF
7) User Data whiten OFF
Enter selection or ESC to previous menu >
