SATELLINE-EASy Pro 35W
User Guide v.1.4
41
•
Connect MODE-pin to ground (if using the NARS-1F adapter, slide the switch
downwards), the radio modem shifts now into the
Programming Mode
. The screen should
look similar to the one shown in the picture below.
•
Make desired changes to the settings with SaTerm.
•
Save changes by pressing ”E” in the main menu. If you don’t want to save changes, press
”Q”.
•
Disconnect MODE-pin from ground (if using the NARS-1F adapter, slide the switch
upwards), the radio modem should now return to the
Data Transfer Mode
.
***** SATELLINE *****
FW: 06.18.x.xx / HW: SEPT / PV: 05.00 / IM: 05 / S/N: YYMMxxxx
-----------
------------------------------------------------------------------------
Current settings
----------------
1) Radio frequency TX: 438.0000 MHz / RX: 438.0000 MHz /
Ref freq: 438.0000 MHz / Spacing 25 kHz
2) Radio settings Tx power 35W / Signal threshold -115 dBm / FCS OFF /
TX start delay 0 ms / Compatibility Satel 3AS / Call sign OFF
3) Addressing RX address OFF / TX address OFF /
RX address to RS port OFF / TX address autoswitch OFF
4) Serial port 1 ON / 9600 bit/s / 8 bit data / None parity /
1 stop bit
5) Serial port 2 OFF / 9600 bit/s / 8 bit data / None parity /
1 stop bit (TTL)
6) Handshaking CTS Clear to send / CD RSSI-threshold /
RTS Ignored / Pause length 3 bytes
7) Additional setup Error correction OFF / Error check OFF / Repeater OFF /
SL-commands ON / Priority TX / Full CRC16 check OFF /
User Data whitening OFF
8) Routing OFF
9) Tests OFF
A) Restore factory settings
B) INFO
E) EXIT and save settings
Q) QUIT without saving
Enter selection >
9.2.2
Restoring factory settings
The settings that the modem was delivered from the factory are called “factory settings”.
“Restore factory settings” selection is achieved by selecting “A” from the menu list.
Factory settings are restored by selecting ”Y” (YES). By pressing “N” (NO) or any other button no
changes is done and current settings will remain active. The modem will ask this question twice to
make ensure that this is a valid command.
Enter selection >A
