SATELLINE-EASy Pro 35W
User Guide v.1.4
50
Now all of the modifications of the example have been performed and the new values are
displayed:
***** SATELLINE *****
FW: 06.18.x.xx / HW: SEPT / PV: 05.00 / IM: 05 / S/N: YYMMxxxx
-------------------------------------------------------------------------------
Current settings
----------------
1) Radio frequency TX: 468.50000 MHz / RX: 437.00000 MHz /
Ref freq: 460.00000 MHz / Spacing 12.5kHz
2) Radio settings TX power 35W / Signal threshold -110 dBm / FCS OFF /
TX start delay 0ms / Compatibility Satel 3AS / Call sign OFF
3) Addressing RX address ON 0020/0000 / TX address OFF /
RX address to RS port OFF / TX address autoswitch OFF
4) Serial port 1 ON / 19200 bit/s / 7 bit data / Even parity /
2 stop bit
5) Serial port 2 OFF / 9600 bit/s / 8 bit data / None parity /
1 stop bit (TTL)
6) Handshaking CTS Clear to send / CD RSSI-threshold /
RTS Ignored / Pause length 3 bytes
7) Additional setup Error correction OFF / Error check OFF / Repeater OFF /
SL-commands ON / Priority TX / Full CRC16 check OFF /
User Data whitening OFF
8) Routing OFF
9) Tests OFF
A) Restore factory settings
B) Info
E) EXIT and save settings
Q) QUIT without saving
Enter selection >
Press E for Exiting and saving.
The settings of the serial port must be modified to correspond with the settings of the terminal
device that is to be connected to the radio modem.
9.2.10
Modification of handshaking functions
Handshaking related configuration settings can be modified by selecting the options from the
main menu ”6”. In the following example characteristics of the CTS-line (CLEAR TO SEND
TX
BUFFER STATE), CD-line (RSSI-THRESHOLD
DATA ON CHANNEL) and RTS-line (IGNORED
FLOW CONTROL) are changed.
NOTE!
It should be noted that switching the radio modem into
Programming Mode
by connecting the
MODE-pin (see chapter 6.2) to ground (GND) will change the settings of serial PORT 1 to
”9600,8,N,1” automatically irrespective of the serial PORT 1 DATA-mode settings.
