SATELLINE-EASy Pro 35W
User Guide v.1.4
31
Option 2 & 3: 9600bps@25kHz /
[email protected]
Option 1: [email protected] /
Radio Link:Modulation Mode
Compatibility->PCC-4FSK
Compatibility->PCC-GMSK
Compatibility->TRIMTALK GMSK
Radio Link:Scrambling
ON by default
Radio Link:Transmit Retries
(not implemented)
Radio Link:TX ACK Timeout
(not implemented)
Radio Link:Csma Monitoring
Priority (RX=ON, TX=OFF) Default: RX
Radio Link: AutoBase/AutoRover
(not implemented)
Radio Link:Digisquelch
Signal threshold
Radio Link:Forward Error Correction
ON by default using Option 1, 2, 3
(Note: SATELLINE-EASy Pro 35W FEC must be
OFF!)
Radio Link:Local Address (0 by default) Primary RX address (RX1) (OFF by default)
Radio Link:Remote Address (255 by
default)
Primary TX address (TX1) (OFF by default)
Serial Interface:Protocol Mode
Radio compatibility:
Options 1 and 2 = Transparent w/EOT
Timeout
Option 3 = TRIMTALK 450s, RX fitted to PCC
Option 4 = TRIMTALK 450s, RX fitted to
Trimble
Option 5 = PCC Transparent FST
Serial Interface:BREAK to Command
(not implemented)
Serial Interface:Modem Enable: Yes
(not applicable)
Serial Interface:Soft Break Enable
(not implemented)
Serial Interface:EOT value (in 0.01s
units)
Pause length (in serial port byte intervals)
Serial Interface:Digipeater
Delay(in0.01s units)
(not implemented)
Serial Interface:Local Node Repeater
(not implemented)
Frequency Table
Radio frequency
Data Security Code (must be 0=not
used)
(not implemented)
Potential conflicts:
- Pacific Crest Local/Remote addresses are supported in the firmware versions starting
from v3. 46.3
- Repeater function is supported only in the firmware versions starting from v3. 46.3
- Error check and Full CRC16 check must be OFF in SATELLINE modem
- FCS (Free Channel Scanning) feature is not supported by Pacific Crest radios
- Message Routing is not supported by Pacific Crest radios
- SATELLINE RX/TX addressing does not use ARQ scheme like Pacific Crest radios.
- Pac Crest Transparent FST protocol supported starting from firmware version 3.57
