SATELLINE-EASy Pro 35W
User Guide v.1.4
42
Restore factory settings
------------------------
Do you want to restore factory settings? (Y/N)>
PORT 1 of the radio modem is connected to a terminal device or a PC, which is in terminal
emulation state. (This can be accomplished by using a suitable program such as the
SaTerm
program or the Windows™ Hyper Terminal program). Check the wiring of the serial port
connection cable. Terminal device serial port settings must be set to 9600 bps, N, 8, 1 (data
transfer speed 9600 bps, none parity, data length 8 bits and one (1) stop bit). MODE-pin (see
chapter 6.2) is then connected to ground (GND). Following this the radio modem will transmit the
following message to the terminal (certain configuration settings might differ from the ones
shown):
***** SATELLINE *****
FW: 06.18.x.xx / HW: SEPT / PV: 05.00 / IM: 05 / S/N: YYMMxxxx
-----------
------------------------------------------------------------------------
Current settings
----------------
1) Radio frequency TX: 438.0000 MHz / RX: 438.0000 MHz /
Ref freq: 438.0000 MHz / Spacing 25 kHz
2) Radio settings Tx power 35W / Signal threshold -115 dBm / FCS OFF /
TX start delay 0 ms / Compatibility Satel 3AS / Call sign OFF
3) Addressing RX address OFF / TX address OFF /
RX address to RS port OFF / TX address autoswitch OFF
4) Serial port 1 ON / 9600 bit/s / 8 bit data / None parity /
1 stop bit
5) Serial port 2 OFF / 9600 bit/s / 8 bit data / None parity /
1 stop bit (TTL)
6) Handshaking CTS Clear to send / CD RSSI-threshold /
RTS Ignored / Pause length 3 bytes
7) Additional setup Error correction OFF / Error check OFF / Repeater OFF /
SL-commands ON / Priority TX / Full CRC16 check OFF /
User Data whitening OFF
8) Routing OFF
9) Tests OFF
A) Restore factory settings
B) INFO
E) EXIT and save settings
Q) QUIT without saving
Enter selection >
9.2.3
Changing frequency (active radio channel frequency)
The frequency of the active radio channel, TX or RX or both at the same time, can be changed by
selecting main menu selection ”1”. In the example below the TX frequency is changed
from 468.52500 MHz to 468.50000 MHz.
Enter selection >1
Radio frequency setup
---------------------
1) Radio frequency
2) Channel spacing
