1011-530
32
IntelliLINK
Menu Tree
BankGuard PLUS – standard version
Operation
Setup (2 pages)
Product Information
Communications
Communications Setup (2 pages)
Communications Troubleshooting (DNP version)
Unbalance Setup
IntelliLINK Setup
To set up the control device for normal operation, you must:
1.
Connect your portable computer to the control device and start the IntelliLINK
software as described in
Start IntelliLINK Software
on page 29.
2.
Enter the setup parameters for this particular control device as described in
Enter
Setup Instructions
, which begins on page 33.
3.
Disconnect your computer from the control device.
4.
Use the faceplate buttons to set the desired operating mode, as described in
Normal
Operation
on page 49.
The values you enter on the setup screens depend on your electrical distribution
system and details specific to each individual capacitor bank.
!
WARNING
These instructions do NOT replace the need for utility operation standards. Any conflict
between the information in this document and utility practices should be reviewed by
appropriate utility personnel and a decision made as to the correct procedures to follow.
Serious risk of personal injury or death may result from contact with electric distribution
equipment when electrical isolation and grounding procedures are not followed. The
equipment described in this document must be operated and maintained by qualified
persons who are thoroughly trained and understand any hazards that may be involved. This
document is written only for such qualified persons and is not a substitute for adequate
training and experience in safety procedures for accessing high voltage equipment.
The control device is connected to electrical devices operating at primary voltage levels.
High voltage may be present in the wiring to the control device or the control device itself
during certain failures of the capacitor bank wiring or grounding system, or due to a failure
of the capacitor bank itself. For this reason, access to the control device should be treated
with the same safety precautions as would be applied when accessing other high voltage
lines and equipment. Follow all locally-approved safety procedures when working on or
around this control device.
Before attempting to access an existing installation, check carefully for visible or audible
signs of electrical or physical malfunction (do this
before
touching or operating the control
device or any other part of the installation). These warning signs include such things as
smoke, fire, open fuses, crackling noises, loud buzzing, etc. If a malfunction is suspected,
treat all components of the installation, including the control device and associated mounting
hardware, as if they were elevated to primary (high) voltage.
Summary of Contents for BankGuard PLUS
Page 4: ...1011 530 4...
Page 6: ...1011 530 6 Figure 1 Vo versus F P Ungrounded Wye Capacitor Bank...
Page 50: ...1011 530 50...
