Samsung OfficeServ 7000 Series, Programming Manual

Page: 233 / 487

OfficeServ 7000 Series Call Server Programming Manual
© SAMSUNG Electronics Co., Ltd. 2-195
(Continued)
No Option Description
2 OVERFLOW This is the timer value that will cause unanswered calls to a group to
begin also ringing the NEXT PORT (see below) after this timer has
elapsed. If set to 000, no overflow will take place.
3 GROUP
TRANSFER
This is a timer that will determine how long Trunk Line calls transferred
to the group will ring at the group before recalling. If set to 000, no recall
will take place.
4 NEXT PORT This is the station or group number that callers will also ring at if the
OVERFLOW feature has been programmed. The OVERFLOW
DESTINATION can be defined as:
1 COMMON BELL There is a common bell port on each MIS card.
2 RING OVER PAGE The ROP port can be defined as the NEXT port.
3 STATION OR STATION GROUP. Any station or station group can be
defined as the NEXT port.
5 MEMBER List all members that are to be in the group. Up to 48 members for the
system are allowed in each group, but stations can be assigned to
multiple station groups.
6 NEXT HUNT The length of time a call will ring at a station before it hunts to the next
group member.
7 GROUP BUSY When this option is set to ON, a busy signal will be sent to the caller if
all group members are busy. When this option is set to OFF, the ring
back tone is sent to the caller even if all group members are busy.
UCD is an exception to this rule. This option only works when MMC 210
SGR INC BUSY is set to OFF. When MMC 210 SGR INC BUSY is set to
ON, all station groups will follow this setting.
8 GROUP AUTO
ANS
If set ON, stations will automatically answer calls to the group (when
ring type is DISTRIBUTED or SEQUENTIAL)
9 ALLOUT NEXT This is the option to designate whether to transfer the call directly to the
extension (group) designated in the NEXT PORT without waiting during
the OVERFLOW time when all the members of the extension group are
in logged out status. (OFF/ON)
10 RBT MSG This is used when executing the coloring service for the extension
group.
Enter the VMS message number which is to be used for coloring. In
case of the F-STN, this operates according to the extension coloring
message of the receiving group member. (0~9998, F-STN, NONE)
Calls to a group
Calls to a group do not follow the call forwarding instructions of any station in the
group.