Samsung OfficeServ 7000 Series, Programming Manual

Page: 418 / 487

CHAPTER 2. MMC Programming
2-380 © SAMSUNG Electronics Co., Ltd.
SIP Extension Configuration
No Parameter Description Default
00 SIGNAL PORT Sets the UDP port used for a SIP station call. 5060
01 IP-UMS PORT Sets the UDP port used for IP-UMS calls. 5070
02 EXPIRE TIME This indicates how long each registration from SIP
stations will be valid. SIP stations will send the next
REGISTER message before this time value is passed.
600
03 NAT REG EXP Specifies registration expiration time for SIP stations
located under NAT.
600
SIP Trunk Configuration
No Parameter Description Default
00 DEFAULT ISP This field indicates the default SIP Carrier that will be
used for SIP trunking
1
01 iBG EXPIRE When interacting with iBG, iBG sends REGISTER
message to system for link test purpose. The iBG
EXPIRE value indicates the expiration time for the iBG’s
registration.
10
02 LCR SETUP When making SIP Trunk outbound call, there exists time
interval till the outbound INVITE message is actually sent
out unless attaching ‘#’ key in order to let system know
that dialing is done. When LCR SETUP value is set to
Enable, the system sends the outbound INVITE message
immediately
Disable
03 RCV CLI FWD In case outgoing SIP Call, if receiver dose not want
display CLI, set this option to ENABLE and dose not
send CLI information.
Disable
04 INCOM MODE This option selects how incoming calls are routed when
the MGI is used as a SIP gateway.
0 FOLLOW DID TRANS: Follows MMC 714 (default)
1 FOLLOW INCOM DGT: Follows MMC 724
2 FOLLOW TRUNK RING: Follows MMC 406
FOLLOW DID
05 PEER CLIPTB Refers to SEND CLI NUMBER (MMC 323), which
provides calling party identification when sending out a
SIP peering call.
1