ETHERLINK II - Repeater
Manual
Page 96 of 106
ETHERLINK II
LTU
RGNo2
( remote power
)
NTU
SHDSL
SHDSL
SA- PAM- SRL-2E1B/4 Eth- RP , V9
SA- PAM- SA2N-2E1B/ Eth , V8
SA- PAM- RGN- Eth- PL , V8
G. 703
(E1-1)
Management PC
VoIP
Ethernet
Switch
Management PC
VoIP
Repeater Point
G. 703
(E1-2)
ATS
G. 703
(E1-1)
G. 703
(E1-2)
ATS
Ethernet
Network
ETH1
ETH2
ETH3
VoIP
Ethernet
Network
Customer Premises Equipment
Central Office
ETHERLINK II
Note: Both PABXs (ATS in the figure) support the CRC4 mode, if this mode is enabled. Before
setting IP addresses of the system devices, make sure that these IP addresses are not
used by other devices connected to the system. (Enter the PING command to check IP
addresses in all networks connected to the S-Access ETHERLINK_II equipment).
7.2.1 Configuration of the S-Access Etherlink_II device at the Central Office premises.
System configuration (Configuration Management menu):
<DEFAULT EVERYTHING>
–
enable default settings
<POWER ON>
–
switch on remote powering (the modes are activated by
jumpers on the main board)
Line interface configuration (Configuration Management menu):
<MASTER ON>
–
enable the Master mode
Configuration of the internal Ethernet switch (Network Management submenu):
<SETIP 10.0.2.200>
–
set the IP-address of the device (depends on the
configuration of the connected network)
<NETMASK 255.0.0.0>
–
set the subnet mask (this value is the same as in the
connected Ethernet network)
<GATEWAY 10.0.0.101>
– set the default gateway (this value is the same as in the
connected Ethernet network)
<INTERFACE LAN QOS 1>
– packet from the LAN port have priority 1
<INTERFACE WAN1 QOSTHRESHOLD
2>
– VLAN packets with QoS 2 or above have the highest priority
<INTERFACE INT VLAN 3>
– packets of the internal management port belong to VLAN 3
<INTERFACE INT QOS 2>
– packets from the LAN port have priority 0
<INTERFACE WAN1 ALLOW 1,2,3>
– transmit packets of VLAN 1,2,3 over the WAN1 port
Application of all configurations (Fault And Maintenance Management menu):
<APPLY ALL>
–
apply all configurations (written in the running configuration)
