ETHERLINK II - Repeater
Manual
Page 54 of 106
4.5
Command syntax
The following rules are used to describe commands:
parameters in angular brackets
< >
are obligatory;
parameters in direct brackets
[ ]
are not obligatory;
the symbol (
/
)
between parameters requires to enter one of the listed parameters;
in real commands brackets and the vertical line are not entered, they are used for
description;
after the command is typed, press
<enter>
.
4.6
Commands
4.6.1 Main Menu
The main menu is presented as shown below:
MODEL SA_REG_ETHERLINK_II-1DA-IP67, V56
HW 1.6
SW 1.2.8
DATE 27-12-2006
ID
RUNS 0d 01:21:01
ALARM NO
STATUS LINK UP
MODEL_DESC Simple repeater/Ethernet 120 Ohm
IP 192.168.0.235
------------- Main Menu -----------------
1. Performance management (PM)
2. Fault and maintenance management (FMM)
3. Configuration management (CM)
5. Exit
-----------------------------------------
Select [1..5]
RR_01_MM>
To select the desired sub-
menu, type the appropriate number from “1” to “5” and press<enter>.
4.6.1.1 System invitation
The following format of the system invitation is used in all menus:
<
cc
>_<
addr
>_<
sf
>>,
сс
is the device mode [RR
– regenerator, CO – Master; CP – Slave; CX – a modem with both
types of interfaces, CA
– a device with the automatic selection of the DSL line
parameters (<MASTER>, <BASERATE>, <PAM> and <ANNEX>)];
addr
is the address of the regenerator in the system (only for regenerators), or a device in the
shelf (only for Subrack devices);
sf
is the short form of the current menu (MM
– Main Menu; PM – Performance Management;
FMM
– Fault and Maintenance Management; CM – Configuration Management).
