ETHERLINK II - Repeater
Manual
Page 72 of 106
4.6.5.2 <CONFIG> command
The <CONFIG> command displays the configuration of the device.
RR_01_CM>CONFIG
--------------------------------------------------------------------------------
Running Line Configuration
--------------------------------------------------------------------------------
xDSL Side 1 Side 2
Mode : Slave Master
Line coding : AUTO
Baserate : AUTO
Annex : A/B
WAN Payload : 57
--------------------------------------------------------------------------------
RR_01_CM>
Definitions:
Group of xDSL parameters
Mode
Operation mode:
Master
Slave
Auto
Line coding
Type of the line encoding (PAM32, PAM16, Auto)
Baserate
Data transmission rate over the line interface. Auto
– adaptation mode
Annex
Transmission mode (ANNEX A, ANNEX B, ANNEX AB)
WAN Payload
Data transmitted over the WAN interface.
Note: New configuration is displayed automatically every time changes are made to the
configuration.
4.6.5.3 <CONFIG R/N/S/B> command
The
<CONFIG R/N/S/B>
command displays either the running configuration (parameters R, N,
S) or the backup configuration (parameter B).
If a command is used to change configurations of data transmission interfaces, for example
BASERATE or CRC4, the new configuration is displayed if the commands are performed
successfully (in this case these commands are similar to the CONFIG N command). This
is determined by the fact that configurations of the LINE group, which require
confirmation will not be displayed in the running configuration, but will be changed only
in the new configuration. To prevent misunderstanding a warning will be displayed.
