ETHERLINK II - Repeater
Manual
Page 95 of 106
7.1.2 Configuration of the S-Access Etherlink_II device at the Customer Premises.
System configuration (Configuration Management menu):
<DEFAULT EVERYTHING>
–
enable default settings
Line interface configuration (Configuration Management menu):
<MASTER OFF>
–
enable the Slave mode
Configuration of the internal Ethernet switch (Network Management submenu):
<SETIP 10.0.2.201>
–
set the IP-address of the device (depends on the configuration
of the network)
<NETMASK 255.0.0.0>
–
set the subnet mask (this value is the same as in the connected
Ethernet network)
<GATEWAY 10.0.0.101>
– set the default gateway (this value is the same as in the
connected Ethernet network)
Application of all configurations (Fault And Maintenance Management menu):
<APPLY ALL>
–
apply all configurations (written in the running configuration)
Confirmation of all configurations (Fault And Maintenance Management menu):
<CONFIRM>
–
confirm all configurations
(written in the startup configuration)
7.1.3 Configuration of the S-Access Etherlink_II regenerator at the Regenerator Point.
System configuration (Configuration Management menu):
<DEFAULT EVERYTHING>
–
enable default settings
Line interface configuration (Configuration Management menu):
<MASTER AUTO>
–
enable automatic detection of the Master/Slave mode
<BASERATE AUTO>
–
enable automatic detection of the line rate
Configuration of the internal Ethernet switch (Network Management submenu):
<SETIP 10.0.2.202>
–
set the IP address of the device (depends on the configuration
of the connected network)
<NETMASK 255.0.0.0>
–
set the subnet mask (this value is the same as in the connected
Ethernet network)
<GATEWAY 10.0.0.101>
– set the default gateway (this value is the same as in the
connected Ethernet network)
Application of all configurations (Fault And Maintenance Management menu):
<APPLY ALL>
–
apply all configurations (written in the running configuration)
Confirmation of all configurations (Fault And Maintenance Management menu):
<CONFIRM>
–
confirm all configurations
(written in the startup configuration)
7.2
Example 2 of configuration of Etherlink_II devices
An example of a more complex organization of a data transmission system with the help of
Etherlink_II devices is presented below:
