Ryobi RBC254FSB, User Manual

Page: 28 / 296

21
English(Original instructions)
may be necessary to work the muf À er assembly free
from the muf À er gasket.
5. Separate the muf À er cover from the muf À er.
6. Remove the three screws that hold the plates on the
muf À er.
7. Remove the spark arrester.
8. Replace with a new spark arrester.
9. Reassemble the muf
À er by reinstalling the plates
and tightening the three screws (torque to 18 in.lb.
minimum, 22 in.lb. maximum).
10. Reassemble the muf À er and muf À er cover and attach
to the muf À er gasket with the two screws.
11. Reinsert the muf À er assembly and tighten the two
screws to the engine (torque to 60 in.lb minimum, 80
in.lb. maximum).
12. Reinstall the cover on the tool and fasten with the
¿ ve screws (torque to 16 in.lb. minimum, 22 in.lb.
maximum).
NOTE: Do not overtighten screws.
NOTE: Depending on the type of fuel used, the type
and amount of lubricant used, and/or your operating
conditions, the exhaust port, muffler, and/or spark
arrestor screen may become blocked with carbon
deposits. If you notice a power loss with your gas
powered tool, a qualified service technician will need
to remove these deposits to restore performance.
STORING THE PRODUCT
Short term storage
Ŷ Clean all foreign material from the product.
Ŷ Store the product in a well-ventilated place that is
inaccessible to children.
Long term storage (1 month or longer)
Ŷ Drain all of the fuel from the tank into a container
approved for gasoline.
Ŷ Run the engine until it stops.
Ŷ Clean all foreign material from the product.
Ŷ Store the product in a well-ventilated place that is
inaccessible to children. Keep away from corrosive
agents such as garden chemicals and de-icing salts.
Ŷ Abide by all government and local regulations for the
safe storage and handling of petrol.
INSPECTION AFTER DROPPING OR OTHER IMPACTS
Thoroughly inspect the product and identify any affections
or damage with it. Any part that is damaged should be
properly repaired or replaced by an authorized service
centre.