VC-400RT
+
Managed VDSL2 CPE Router MANUAL Ver. A5
93
The screen contains the following details:
Fields in DS-Lite Configuration:
Field
Description
General Settings
Enable DS-Lite tunnel
To enable/disable DS-Lite functionality in CPE.
WAN Interface
Select WAN interface from dropdown on which
DS-Lite
tunnel has to be created.
Configuration Modes
Modes to configure DS-Lite tunnel on a WAN
interface.
Currently, Static, Dynamic(DHCPv6 option-64) and
Lw4o6
DS-Lite modes are supported.
MTU
Optionally, it is used to specify Maximum Transfer
Unit size
for DS-Lite tunnel.
Static Parameters
DS-Lite Remote IPv6
address
IPv6 address of the remote tunnel endpoint.
(When you
select Dynamic mode, this field is disabled.)
DS-Lite tunnel IP
address (IPv4)
IPv4 address of the remote tunnel endpoint.
Subnet Mask
IPv4 Address subnet mask.
Lw4o6 Port Range
This is the port range for Source NAT.Applicable
only for
Lw4o6 type.
Click Apply at any time during configuration to save the information that you
have entered.
Click CANCEL to exit from this page without saving the changes.
4.15 Diagnostics
When you click Diagnostics link on the left navigation bar of the VC-400RT+ CPE homepage.
The menu below includes the sub-menus of
Diagnostic Test Suite
. The following options are
available under Diagnostics as shown in Figure 4.15
Figure 4.15 Diagnostics Options