VC-400RT
+
Managed VDSL2 CPE Router MANUAL Ver. A5
69
The screen contains the following details:
Fields in“Add a Packet Filtering Rule” page:
Field
Description
Protocol
To select the protocol. The options available are ALL, TCP,
UDP, ICMP, AH and ESP.
Source IP
The source IP can be a SINGLE address or a SUBNET,
involving a range of IP addresses.
IP Address
To specify the source IP address.
Netmask
To specify the netmask for the source address.
Source Port
To specify the range of the source port. Valid for protocols
TCP or UDP only.
Destination IP
Type
The destination IP can be a SINGLE address or a SUBNET
or All involving a range of IP
addresses.
IP Address
To specify the destination IP address.
Netmask
To specify a netmask for the destination IP address.
Destination
Port
To specify the range of the destination port. Valid for
protocols TCP or UDP only.
Ingress
Interface
To specify the input interface of the packet from dropdown
options. (e.g. WAN1).
Egress
Interface
To specify the output interface of the packet from dropdown
options. (e.g. WAN2).
Source MAC
Address
This is the source hosts’s MAC address.
Enable
To enable/disable the particular packet filtering rule.
Click Apply at any time during configuration to for adding the packet filtering
rule.
Click CANCEL to exit from this page without saving the changes.
Figure 4.9.3.2 Add a Packet Filtering Rule for Firewall - IPv6