Roxell Vitoo In Line, Use And Assembly Manual

Page: 89 / 106

ROXELL - 008- 3911 VITOO IN LINE -- INSTALLATION INSTRUCTIONS
III--35
TO INSTALL THE AUGER
ALWAYS USE SAFETY GLOVES WHEN YOU WORK ON THE AUGER !
Remove all wires, labels etc.. from the auger.
FIGURE 67.
TAKE CARE THAT THE AUGER DOES NOT UNROLL !
If the auger is kinked or bent: straighten it by plying it
over the upper leg.
FIGURE 68.
Put the auger coil about 4m from the feed intake boot.
One person Gradually unrolls the auger while a second
person gives short pushes (MAX 40cm to avoid bend-
ing and kinking) to slide the auger into the tube.
4M
Remove the anchor from the feed intake boot.
FIGURE 69.
OPTION : USE OF THE AUGER INJECTOR KIT : SEE PAGE III- 44
Pull the auger until it stretches, then let it relax. Mark the
auger at the edge of the feed intake boot.
FIGURE 70. FIGURE 71.
Put the thin edge to-
wards the gearbox.
Feed intake boot.
M
Fix the auger to the drive shaft of the gearhead with the
drive block.
M6X35