Roxell Vitoo In Line, Use And Assembly Manual

Page: 16 / 106

ROXELL - 008 - 3911 VITOO IN LINE -- INSTRUCTIONS FOR THE USER
I--10
Now you can remove the top support BY PRESS-
ING THE CENTRAL LIPS.
FIGURE 15.
REMEMBER TO COVER THE MOTORS WITH
WATERPROOF COVER !!
Motors and switches are insulated IP54, which means that
they resist splashing, but certainly not a high pressure
cleaner.
The
feeder pan
, made of high quality polypropylene,
resists practically all cleansers and disinfectants.
However, if you want to use an aggressive product (1), you
should contact your supplier.
Put the OPERATOR’S MANUAL on the house wall at an
eye--catching spot.
(1) NB : Gaseous formaldehyde (formalin), liquid
caustic soda, hypochlorite or chlorine water, cresoles
are very corrosive and affect the system in no time !
BEFORE THE BIRDS ARRIVE.
First check the operation of your system.
Check the operation of the control panel :
-
time clock
-
sensor
Check the feed supply system : any leaks / obstructions.
Check the accuracy of the weigher.
Adjust the feed level of all pans at the same position (See
graph page ...).
Check tension of the antiperch cables.
Make sure that all lines are perfectly level. Motors must
hang at the same height.
ELECTRICAL PART :
STARTING UP AND OPERATION.
The central control panel (several models for Kixoo)
operates the whole system. It is built according to the
system to be installed.
Example :
To distribute the total amount of feed in one automatic cycle,
you program enough time on the time clock -- e.g. 2 hours
from the start.
If you want to feed at 8 o’clock, program the time clock from
8 to 10 o’clock.
Set the preselection counter at the desired amount of feed
(depending on the weigher type).
The main switches on ”ON”.
The lines will start at 8 o’clock. The amount of feed set is
evenly distributed over all lines.
The value on the preselection counter decreases at each tip-
ping of the weigher.
This continues until the counter arrives at the ”ZERO” val-
ue.
The process is repeated until the counter reaches the ZERO
value. At that moment, the system stops IMMEDIATELY
and the lamp ”PROGRAM ON” extinguishes.
From the moment the time clock has finished its course,
you can reprogramme the preselection counter.
Now the system is ready for a new cycle.
THE COUNTER IS NOT AUTOMATICALLY RE--ADJUSTED: YOU MUST RE--ADJUST
IT MANUALLY EVERY DAY, AFTER THE FEEDING CYCLE HAS ENDED.